HARMONY KEYBOARD DRIVER WINDOWS 10 MANUAL

it shuts down to S5 with no hibernation file)Д¬IR activated and Wake via CIR from S3, S4, S5 activated Power On works properly for waking from S5 via CIR. The only device I found currrently being able to start the NUC via CIR properly is the Microsoft Windows Media Center PC, which includes besides Power Toggle also designated Power On and Power Off commands. A friend even reproduced this problem on his NUC6CAYH using an actual MCE remote controller. I've tried several other device settings on the Harmony, including setting it up as Intel NUC6CAYH (which however has significantly less command options than the MCE Keyboard). But after a few minutes, it will only react on the second Toggle command. When pressing Power Toggle again immediately within a few seconds, sometimes the NUC will start. Once booted, a 3rd Power Toggle shuts down the NUC. When pressing it 2nd time, the NUC boots. I.e., when the NUC is in S5 shutdown state and I press Power Toggle 1st time, nothing happens.

HARMONY KEYBOARD DRIVER WINDOWS 10 MANUAL

(It is only possible in manual operation). However, sending a power command twice is not possible within a Harmony action. When trying to wake up the NUC from S5 via CIR, the Toggle command is recognized by the NUC only when sending it twice. For switching on/off, the MCE Keyboard uses a Power Toggle command. In the Harmony, I set up the device 'Microsoft MCE Keyboard' for switching on/off and controlling the NUC via its internal IR sensor.

I'm using the NUC as a HTPC and control it using a Logitech Harmony remote.

I have the following reproducible problem with my NUC6CAYH:

Harmony keyboard driver windows 10